Ec20 Mixer- Retrofit Bowl Guard

Crypto Peerless EC20 Mixer- Retrofit Bowl Guard

Fitting Instructions
Place the two side wings approx 4-5mm below underside of mixer to allow for casting radius, flush with edge of column and mark the position of the 2 fixing per wing on column, drill and tap for 6mm screws(or drill clearance and retain with nuts) attach the two wings. Mark & drill vertical from underside, a hole for cable to pass into Body of machine. Route cable into body of machine and connect wires in series with stop switch. i.e between terminal 2 on potentiometer & stop push button, on machine fitted with Tuscan motors or between terminal 4 on PCB and stop push button on machine fitted with Biamain motor. Fit Bowl Guard around planetary casting and position with approx 20mm between top of the bowl and the 4 guard pillars. Tighten the 4 grub screws to secure in position. Test for suitable operation and if necessary align by adjusting either wings or guard.